![]() Local drives use Apple's HFS+ format - they will not even work with Apple's newer APFS disk format. USB use a different format for Time Machine to network servers e.g. Is there any way to preserve those backups, or should I just reformat the drive and start fresh?Ģ) If I'm starting over, should I format it in APFS, and should I make separate partitions or containers or folders to back each up to, or just leave it after formatting and let the software figure it out?ģ) Will everything continue to backup as long as the iMac is turned on, even if it's asleep overnight?Īs I mentioned local drives i.e. Each of the 3 computers have their own partition on the drive. I've read about it and have the general setup figured out but still have a couple questions.ġ) I've been backing up all 3 computers by connecting each via USB to do the Time Machine backups as needed. It seems that minor update does not work with the bootloader as SATA disk.īut it seems to be working good with the bootloader as USB disk and its vid/pid modified to match usb disk.Time Machine Backups to external drive over network Until I have the time to buy and figure out using a NAS, I'm going to try to connect an external WD Red HD (in a 3rd party enclosure) to my iMac running OS 11.6 and share the drive to do Time Machine backups for a MacBook and MacBook Air (also running OS 11.6) over my Orbi wireless network. Unfortunately, you will have to reinstall and reconfigure all your apps. Then, re-attach your data disks to the vm.Then, reload your dss configuration previously saved.Then you may need to proceed to a clean (re)install of the dsm (check here).If your dsm operating system is slow and then freeze later on Note: Consider to (re)install your dsm os on a dedicated vm disk in order to isolate it and get easier maintenance. Select : "Migration: Keep my data and most of the settings"Ĭlick "Browse", then select "DSM_DS3615xs_25426.pat" file If sata disk (raw file), backup by copying the file then replace this file by coying the new bootloader overiding the file. If usb disk, change vm conf file to set the path of the new bootloader. If you have isolated your dsm OS by installing it in a specific vm disk, then proceed to a proxmox backup first. Then detach (or comment in vm conf file) all disks, except bootloader and disk containing DSM OS. On "Configuration Backup" tab, click Backup configuration button.Go to "Control Panel > Update and Restore".If the bootloader is confirmed to be working with this major update, then look in forum for positive feedback with an equivalent configuration. You will have to wait for a new compatible bootloader. If there is no bootloader working with the next major update, then DON'T PROCEED. Then click Update Now, and click Yes at the confirmation promptįirst, you need to check, in /forum/, if the bootloader is confirmed to be working with the next major update:.Then if ok, just do a normal synology update as usual through "Control Panel > Update and Restore" and select "Download DSM updates but let me choose whether to install them" (or equivalent)Ĭheck if there is no issue with the update on /forum/forum/78-critical-updates/ with an similar configuration.click "Update Settings" then check "Important updates only" (if available).Go to Control Panel > Update and Restore.It's highly recommended to disable automatic update as follow:
0 Comments
Leave a Reply. |